Broadhead development update

For all the things we make ourselves for the outdoor world that are not covered in the other specific DIY area.
Message
Author
Longtrad
Posts: 1413
Joined: Sun Sep 18, 2016 2:26 pm

Re: Broadhead development update

#21 Post by Longtrad »

the keyboard i suppose :lol:

User avatar
Tradman
Posts: 1833
Joined: Fri Mar 11, 2011 11:53 pm

Re: Broadhead development update

#22 Post by Tradman »

I am going to make a broadhead out of a single piece of aluminium foil. :arrow: :idea: :roll:
IT'S NEVER WRONG TO DO WHAT'S RIGHT AND IT'S NEVER RIGHT TO DO WHAT'S WRONG....LOU HOLTZ

User avatar
Ole Dave
Posts: 525
Joined: Mon Sep 19, 2016 5:22 am

Re: Broadhead development update

#23 Post by Ole Dave »

Tradman wrote:I am going to make a broadhead out of a single piece of aluminium foil. :arrow: :idea: :roll:

Foil wrapped backstraps! :shock: :lol:
All we have and call our own, once belonged to someone else, and will again. Our purpose here is not to serve ourselves.

Bigfoot SAS LB (47# LB limbs 38# Semi Static RC limbs)

Couple of old Bear bows

Mitch Edwards
Posts: 147
Joined: Sat Sep 17, 2016 11:23 am

Re: Broadhead development update

#24 Post by Mitch Edwards »

No further on paper only in thought. Thinking about going the solid machined route. To many decisions. Solid machined will be more expensive but less risky with my money. If you remove brazing from the equation it gets a lot simpler. One piece designs have their own kinks unless you have the right machine. Sadly I don't. Would have to be done in multiple setups which is doable but time consuming. May just get some cheap mild steel and start cuttin to see if I can even do it.

Captainkirk
Site Admin
Posts: 12787
Joined: Tue Aug 26, 2014 8:19 pm

Re: Broadhead development update

#25 Post by Captainkirk »

I can wait..... 8-)
Aim small, miss small!

Post Reply

Return to “DIY section”