Store bought knife build?

[Grizzly]

+1

[Graps]

This blade is 5 3/4" long and .068" thick.
440C stainless and I got it from Texas Knife Works.

20190417_160123~01.jpg (81.8 KiB) Viewed 607 times

[Graps]

Mark about where the handle will stop.

20190417_160224~01.jpg (93.48 KiB) Viewed 607 times

[Graps]

20190417_160350~01.jpg (89.11 KiB) Viewed 604 times

I like to mark the scales how they match up.

[Graps]

20190417_182230~01.jpg (63.84 KiB) Viewed 603 times

Then after determining where I want the handle to be cut out of the scale, I clamp one of the scales outside in on the knife.

[Graps]

20190417_183534~01.jpg (73.1 KiB) Viewed 602 times

I drill the scale in place.
In this case they have slots instead of holes but that is ok because the pins will keep the scales aligned so they will match both sides.

[Graps]

20190417_183847~01.jpg (89.19 KiB) Viewed 601 times

20190417_184026~01.jpg (104.06 KiB) Viewed 601 times

Then I clamp the blocks together and the marks are opposite so the scales will be " book ended "
And drill the holes through the other scale.

[Graps]

20190417_184131~01.jpg (98.89 KiB) Viewed 599 times

Good idea at this point to mark the inside of the scales so it's easier to see how they go on the knife.
BEFORE I PUT THE EPOXY ON.
Wonder how I know that?

[Graps]

20190417_184636~01.jpg (104.13 KiB) Viewed 598 times

With the pins on one side I align the scale on the knife and trace around the handle.

[Graps]

20190417_184718~01.jpg (87 KiB) Viewed 597 times

20190417_184814~01.jpg (90.87 KiB) Viewed 597 times

Then I bandsaw the profile leaving it oversized.