Tradhunter - Traditional Archery Bow Hunting Forums

I put a little strip of double sided tape inside to help hold it in place. Here it is doing its job..

Then if you're in a rush you can do this..

If your old and lazy like me you can just use sandpaper. I don't like getting up and down..

Sand it down as smooth and thin as you want. Sometimes I will take a sharp knife and trim the sides a little when the quill is to wide still. After that you finally have a feather ready to use.

Here's what one looks like that was stripped. You just glue the thin membrane without the white inside part of the quill.

This is what a stripped feather looks like on an arrow. These have been shot for two years or more. If you look closely you will see that the stripped feathers will begin to get wavy, they still shot good. This is left wing 5" feather.

These are 4" right wing feathers that have years of use also. But these are the ones that were split, chopped, and sanded leaving the white interior for strength. No waves in these, your choice.

If you are seeing red in the stripped feather it's because on the other side I take a red felt tipped pen and color the white parts, your looking at the back side above where it bled through. The last picture has that also but it is turned away from you.

Scaler made a good point, if you like to make flu-flu arrows use the strip method, they will spiral around the arrow easily.

The way you sanded those is how I do it, except I sand the feather before I chop it. They sure come out nice, look just like the ones you buy. Now I am going to try some goose feathers I got from a friend, heard they do real well in wet weather. Anyone out there have any tips for the goose? I plan on just doing it like the turkey for now.